? Persons trained in the local and national electrical standards must perform AL2 PDF all
tasks associated
AL2 AL2 Manual with wiring the α2 Series AL2 PDF Controller.
? Disconnect all terminals from power supply before removing the cover.
? AL2 Manual AL2 PDF Turn off the Power before performing any wiring operations.
? Input and output cables AL2 Installation Manual should not be run through the same multicore cable or
share the same wire.
? Input and Output AL2 Installation Manual cable length must be less than 30m (98' 5").
? The wire should be used a single cable, AL2 Installation Manual used a crimp terminal, or carefully
twist stranded wires together.
Do not connect a soldered wire end to the α2 Series Controller.
? To avoid damaging the wire, tighten to a torque of 0.5 - 0.6 N?m.
? Do not install in areas with: excessive or conductive dust, corrosive or
flammable gas, moisture or rain, excessive heat, regular impact shocks or
excessive vibration.
? The connectors must be covered to prevent contact with “Live” wires.
? The α2 Series Controller must be installed in distribution box or a control
cabinet.
? Leave a minimum of 10mm of space for ventilation between the top and bottom
edges of the α2 Series Controller and the enclosure walls.
? The α2 Series is not designed to be used in life critical or fail safe applications.
? Under no circumstances will Mitsubishi Electric be liable or responsible for any
consequential damage that may arise as a result of the installation or use of
this equipment.
? Please read the α2 Series Hardware and α2 Series Programming Manuals
for further information.
Mitsubishi AL2-2TC-ADP Manual Controller AL2-2TC-ADP PDF.
Mitsubishi AL2 Manual Controller AL2 PDF.
Mitsubishi AL2 Controller Manual PDF.
Mitsubishi AL2 Manual PDF.
Mitssubishi AL2 Manual AL2 Series PDF Manual Application Controller.
AL-ASI-BD/AL2-ASI-BD Manuaal AL2 PDF Mitsubishi AL-ASI-BD/AL2-ASI-BD PDF Hardware Manual.